7451 Oakmeadows Drive Worthington, Ohio 43085 | (614) 847-9410

T-REX Carbide Surfacing Pictures



T-REX Carbide Surfacing applied to the faces of Ultrasonic Welding horns extend the life of the horns by as much as ten-fold, especially when ultrasonic welding tough materials like modern filled or reinforced plastics.

______________________________________________________



T-REX Carbide Surfacing can be applied even over very small surface areas such as these small Ultrasonic Welding horn tips with diamond pointed grips. The sides of these diamond points are less than 0.020" wide, yet the point tips are still intact. These T-REX Carbide Surfaced horn tips last almost ten times as long as a standard machined tip, yet only cost slightly more than a standard tip. This is not only a great direct cost savings, but because there is less machine down-time to change tips, this is also represents a great secondary cost reduction.
______________________________________________________





T-REX Carbide Surfacing can be applied on large areas such as this large ultrasonic welding horn. The T-REX Carbide Surface does not change the weight of the horn but due to it's inherent ability to hold a surface better than a standard horn, parameters can be reduced while still producing great welding results thus resulting in even longer horn life.
______________________________________________________